I Series - DTF Film 13" x 328' (33cm x 100m)

13" x 328' (33cm x 100 meters) Hot Peel DTF Film for DTF 12H2 model printers.

This is a direct replacement for the previous 12" film.  Please open a support ticket at https://support.coldesi.com/open-a-ticket for assistance with setup if needed.

IMPORTANT: New Formula

• Time: 10 seconds / 5 seconds 
• Temperature: 300°F 
• Pressure: 7 / Firm Pressure

1. Design will be printed as a mirror image with the white ink on the surface.
2. Place the garment on the heat press and lay the direct-to-film transfer on the garment with the image (right reading) facing up.
3. Press with a firm pressure at 300°F for 10 seconds.
4. For Hot Peel, start from a corner with the most ink coverage and remove in one, rapid motion (like removing a bandage).
   For Warm or Cold Peel, remove the garment from the heat press and then peel the film off.
5. Place the garment on the heat press and cover with a standard or Teflon finishing sheet. Press for 5 final seconds.