Spangle application instructions >>>

After your design is completed by your ProSpangle machine..

• Set the heat-press to 288 degrees Fahrenheit (285-290 degree range).


• Set the timer to 12 seconds.


• Place a Nomex heat pad on the bottom platform of your heat-press or use a lower platen Teflon cover; depending on your brand and style of heat press.


• Adjust the upper platform so the pressure is high, but still able to lock down. (If your machine measures 0-9 pressure, it should be set to 7)


• Pre-press your garment to flatten out any wrinkles, and then allow it to cool.


• Cut away any excess transfer paper that serves no purpose.


• Place spangle design on the garment.


• Lower heat-press for 12 seconds. Once finished, remove garment and lay out flat, design downward, on your work table.


• Rub the design to assist in cooling. (Recommended to use a shirt or cloth to protect hand from heat)


• Warm peel (Not HOT or COLD) transfer paper off in whichever motion works best for that design.


• If you feel any spangles are not 100% secured after peeling, press a second time for just a few seconds.

If any spangles come off during this peel, you can cut out the transfer paper that holds the spangle dot(s) and replace it where it belongs. Your cut out does not have to be too precise as to hold just the one little dot(s), it should be of a workable size. Reheat the whole design for just 5-6 seconds. Press the dot(s) firmly. Be careful not to move any of the others spangles since they will be vulnerable to movement. Allow the 'dot' to cool then carefully peel off the transfer paper cut out. This second pressing will serve as the second press for the whole design.

Washing / Drying instructions

• As with most decorated garments, care should be taken when laundering.
• Turn the garment inside-out, if possible.
• Do not launder with rough items within the same washer.
• Use Gentle Cycle. Water temperature should be Cold or Warm, but not Hot.
• Drying is your choice: Hang to dry, or use Low Heat settings.