I Series - DTF Film 13" x 328' (33cm x 100m)

13" x 328' (33cm x 100 meters) Hot Peel DTF Film for DTF 12H2 model printers.

This is a direct replacement for the previous 12" film.  Please open a support ticket at https://support.coldesi.com/open-a-ticket for assistance with setup if needed.

IMPORTANT: New Formula

• Time: 10 seconds / 5 seconds 
• Temperature: 300 degrees Fahrenheit 
• Pressure: 7 / Firm Pressure

1. Design will be printed as a mirror image with white ink on surface.
2. Place garment on heat press and direct to film transfer onto garment with image (right reading) facing up.
3. Press with firm pressure at 300°F for 10 seconds.
4. For Hot Peel, Start from a corner with the most ink coverage and remove in one, rapid motion (like removing a bandage). For Warm or Cold Peel, remove garment from heat press and then peel film off.
5. Place garment on heat press, cover with standard or Teflon finishing sheet and press for 5 seconds.