Heat SEAL Roll - 19" X 10 Yd

Description

HeatSEAL Roll will be your answer for smaller runs of patches, emblems, and badges. This film will be attached to the backside of a finished embroidered image.

It's recommended to accompany our 'Patch-Mat' material, giving you the ability to cutout the patch with a hot knife. All edges will be nicely sealed. The finished edge will not look quite like a patch that has gone through a 'merrowing' machine, but will stay together and be the best you can produce in smaller quantities from start to finish.
HeatSEAL can then give the end-user the choice to iron-on or heat-press the patch to the garment or become a 'sewn-on' patch. A hook-n-loop type attachment is also a viable choice.

Comes as a roll, 19" wide by 10 yards long. Also available in a one-yard sheets and a 100 yard roll.
Product thickness: 7mil

To bond HeatSEAL to back of emblem/patch material:
330-350 degrees / 40-50 psi / 10 seconds press time / flip and press again

To bond patch to garment:
330-350 degrees / 60-80 psi / 10-15 seconds press time on the front-side / flip and press from the back-side 20-25 seconds


PS - The HeatSEAL glue product has two somewhat discernible sides, but there is no difference from one side to the other. This is simply a sheet of heat activated glue.